Decorations (ribbons, cords, candles…)
A hoop with a 15 cm diameter (a dreamcatcher); 0.80 mm binding wire
snipping pliers; flat nose pliers (tightening and modifying the binding wire)
Snip off about 1 m of binding wire.
Twist one end of the wire about 3x around the hoop. Let the short end stick out.
Gradually string the FPB1. Gradually wind the stringing. There are seven winds around the hoop.
Twist the second end of the wire. Place it behind the twist of the first end. It is good, if the FPB1 slightly overlap. This hides the ends of the wires better.
Snip off the protruding wire ends. Press the twists together.
Continue with the FPB2. Make a twist near the first wire. Repeat steps 2-5.
Continue with the FPB3. Make a twist near the previous wires. Repeat steps 2-5.
Continue with the FPB4. Make a twist near the previous wires. Repeat steps 2-5.
Decorate the wreath. You can concentrate on the place where the wires end. Hide the twists.
Share this project with your friends