For Little Fairies

Difficulty: 2
Technique: Basic Beadweaving, Stringing

Simple necklaces made from PRECIOSA Pip™ and PRECIOSA Pellet™

These simple, but distinctively colorful necklaces made using popular beads and seed beads from the PRECIOSA Traditional Czech Beads™ brand in bright opaque colors are sure to be a hit fashion accessory appreciated by young and old alike.


Helena Chmelíková

She is able to switch from luxurious and extravagant fashion show pieces to the preparation of hobby projects,

Learn More


Step 1

The flower

Alternately string 5x Pip and 5x R10 and then thread the line through them one more time. Start tying the ends of the line, create a strong  knot and insert it in the centre of the P; thanks to its shape, it will hold its position without being sewn in. Tie the second and third knots.
Pull the ends of the line into the holes of the surrounding beads. You need 5 flowers on the necklace.

1 / a

Step 2

Stringing the flowers

Cut off about 55 cm of the wire. String the flowers with 10x R10 between them. String the flowers using the hole in the so that two petals are facing upwards and three downwards. Monitor the direction of the stringing and the orientation of the P. Always string them from the rear. Do not overly tighten the stringing. Let the R10 slide freely.

2 / a

Step 3

Finishing up

You do not need to string anything onto the remainder of the wire at the sides. Cut the wire 13 cm from the flowers on both sides of the necklace in order to ensure a total length of 40 cm. String the hole of the two-cut tip onto the end of the wire. Crimp the crimp bead onto the end of the wire and close the two-cut tip. Twist a loop in the wire from the two-cut tip. Hang the fastening on it using the ovals.
The carabiner should be on the right and the counterpiece should be on the left. Otherwise, you can shorten the wire. String 13 cm of R10. String the metal crimp bead at the end. Return the wire to the metal crimp bead. Thread it through the pair of R10. The wire will form a loop. Crimp the metal crimp bead and cut off the excess wire. Attach the fastening to the loops.

3 / a