A 0.20 mm nylon line; a thin needle; scissors; snipping pliers; needle nose pliers
A 40 mm eye pin; an 18 mm eye pin; 4 mm rings; earring hooks
Sew through the T carefully.
String 5x T. Tie them off. Thread the line through both holes in the T nearest to the knot.
Thread the line through the second holes in the T. Add 2x T into each gap. After connecting them all around, thread the line through both holes in the T.
Thread the line through the second holes of the T. Add 1x T to each gap. After connecting them all around, thread the line through both holes at the T.
Repeat Step 3 a total of 7 more times (so that you sew it a total of 8x).
Reduce the T. Only string them into every second gap. Imitate the layout in Step 2. Do not tighten.
Thread an eye pin through the tube. String 2x B onto it.
Also thread the line through the second holes of the T. Tighten. Thread it through several more holes one more time. Finish between the T in the body of the tube. Make sure that the eye pin does not fall out.
Shorten the eye pin. About 8 mm of wire should protrude above the tube. Grasp the wire between the points of the needle nose pliers. Twist it around the point. Gently tighten the eye "back" behind the T, so that it is located in the centre above the tube.
Sew the second earring.
Link a B onto eye pins. Hang them from the eyes next to the tubes.
Hang an earring hook on the second eye using a ring.
You can create various patterns on the tubes.