An 8 mm ball according to the variant shade
Any 5 mm ball
A 50 mm eye pin; 5 mm rings; a carabiner; a metal part to be hung on the end
A 0.20 mm nylon line; a thin needle; scissors; flat nose pliers; needle nose pliers
String 4x R10, 1x T, 2x R10 and thread the line through the T one more time. Repeat this another 3x. Tie it off. Thread the line through the T and the R10 above it.
String 1x R10, 1x T, 2x R10 and then thread the line through T again. String 1x R10. Thread the line through the 2x R10 from Step 1. String 1x R10. Add R10 and T to the next three gaps in the same way and then thread the line through the R10 from Step 1. Connect it in the R10. Thread the line through the T and the 2x R10 above it.
Add another layer in the same way as in Steps 1 and 2. Continue in the same way until you reach the 8th layer.
Do not add R10 above the T in the 9th and last layer. String 1xs R10, 1x T and 1x R10 into the gaps. Sew the line in after connecting it.
String 1x B8 and 4x B5 onto an eye pin. Thread it through the cavity in the middle of the cylinder. String 1x B8 onto an eye pin.
Create an eye on the remainder of the wire from the eye pin. Grasp the wire between the points of the pliers and twist.
Use a ring to attach a carabiner to one eye and the metal hanging part to the other end.