Bracelets made from table cut beads

Step 1

Bracelet with Rectangles

String fifteen rectangular beads onto eye pins which you should also close with an eye of the same size on the second side of the bead. Their colors can be variously combined. The eye pin already has the basic eye ready. String a bead on it and use the needle nose pliers to form an eye on the opposite end behind the bead. The points of the pliers converge and are shaped as cones. Choose the place which best corresponds to the size of the basic eye. Grasp the end of the wire there and twist it around the point. (an illustration of how to make the eye). Both eyes should be in a single plain with the same twist (figure no. 1). They can be evened up using the flat nose pliers. It the eye pin is too long, snip off the end using the snipping pliers. String the prepared eyes onto the doubled stringing material (two fibres of flexible stringing material) with 7x R9 between them. String 1x R9 and 2x FPB4 into the last gap and then 1x R9 again. The FPB4 are used to hide the double knot. (figure no. 2). Adjust its size to the size of the hole in the bead. Cut off any excess stringing material about 2 - 3 mm from the knot. Pull the knot into the bead. Proceed in the same way on both sides of the bracelet.